View Power Supply Parameters

Perform this procedure to view information about the operating status of the power supplies.

Procedure

  1. In the navigation pane, expand Configuration > Edit.
  2. Select Power Supply.
  3. Select the Detail tab.

Detail Field Descriptions

Use the data in the following table to use the Detail tab.

Name

Description

Id

Specifies the ID number.

This field is not supported on all hardware platforms.

Type

Describes the type of power used.

Description

Provides a description of the power supply.

SerialNumber

Specifies the power supply serial number.

HardwareRevision

Specifies the hardware revision number.

PartNumber

Specifies the power supply part number.

PowerSupplyOperStatus

Specifies the status of the power supply as one of the following:

  • on (up)

  • off (down)

InputLineVoltage

Displays the input line voltage:

  • low 110v—power supply connected to a 110 Volt source

  • high 220v—power supply connected to a 220 Volt source

  • ac110vOr220v—power supply connected to a 110  Volt or 220 Volt source

OutputWatts

Displays the output power of this power supply.

InputOperLineVoltage

Displays the operating input line voltage.

If the power supplies in a chassis are not of identical input line voltage values, the operating line voltage shows the low 110v value.

This field is not supported on all hardware platforms.

InputPower

Displays the input power of this power supply.

This field is not supported on all hardware platforms.

FanFlowType

Note:

Exception: only supported on VSP 7200 Series

Displays the airflow direction of the power supply.