Viewing SLPP information for a port

Show SLPP information for a port so that you can view the loop information for a port.

Procedure

Enter Privileged EXEC mode:

enable
View SLPP information for a port:

show slpp interface GigabitEthernet [{slot/port[/sub-port][-slot/port[/sub-port]][,...]}]
Clear SLPP packet RX counters:

clear slpp stats port [{slot/port[/sub-port][-slot/port[/sub-port]][,...]}]

Example

Switch# show slpp interface GigabitEthernet 1/7

================================================================================
                                    Port Interface
   ================================================================================
   PORT        PKT-RX      PKT-RX     INCOMING   SLPP PDU
   NUM                     THRESHOLD  VLAN ID    ORIGINATOR
   --------------------------------------------------------------------------------
   1/7         enabled     5
      
   PORT        PKT-RX      TIME LEFT
   NUM         COUNT       TO CLEAR RX COUNT
   --------------------------------------------------------------------------------
   1/7         29          21600

Variable Definitions

Use the data in the following table to use the show slpp interface GigabitEthernet command.


Variable	Value
{slot/port[/sub-port][-slot/port[/sub-port]][,...]}	Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.