Use the following procedure to run the SPBM script to configure the IS-IS port interfaces. As this command does not flap IS-IS or SPBM, it is particularly effective to use this command when SPBM is already configured and you require to configure additional ports or MLTs. Running the run spbm interface command does not alter existing IS-IS or SPBM configurations.
You can use this procedure to quickly configure the minimum SPBM and IS-IS parameters. However, a manual procedure is available instead of using this script.
Note
You must enable SPBM before running the SPBM script.
run spbm interface
Note
If the script causes a configuration conflict or cannot execute a command, an error message displays and the script stops.
Run the SPBM script:
Switch:1(config)# run spbm interface
***************************************************************** *** This script will guide you through configuring the *** *** switch for optimal operation SPB. *** *** --------------------------------------------------- *** *** The values in [] are the default values, you can *** *** input alternative values at any of the prompts. *** *** If you wish to terminate or exit this script *** *** enter ^C <control-C> at any prompt. *** ****************************************************************** ISIS port interfaces <a/b,c/d> []:1/2,1/4,1/8 ISIS MLT interface <MLT ID LIST> []:1 *IS-IS on port 1/2 configured* *IS-IS on port 1/4 configured* *IS-IS on port 1/8 configured* *IS-IS on MLT-1 configured*