Configure Wake-On-LAN
Use the following procedure to configure Wake-On-LAN functionality.
Note
This procedure does not apply to VSP 8600 Series or XA1400 Series.
Procedure
-
Enter GigabitEthernet Interface
Configuration mode:
enable
configure terminal
interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
Note
If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
Variable Definitions
The following table defines parameters for the eapol traffic-control command.
|
Variable |
Value |
|---|---|
|
in |
Specifies incoming traffic is blocked when there is no authenticated device. |
|
in-out |
Specifies incoming and outgoing traffic is blocked when there is no authenticated device. The default value is in-out. |