Configure FTP Connection to an IP Address

Fabric IPsec Gateway Virtual Machine (VM) provides a File Transfer Protocol (FTP) CLI to copy the configuration files to the VM.

About this task

Perform this procedure to configure an FTP connection to a specific IP Address.

Procedure

  1. Enter Fabric IPsec Gateway Configuration mode:

    enable

    virtual-service WORD<1-128> console

    Note

    Note

    Type CTRL+Y to exit the console.

  2. Configure FTP connection:

    ftp {A.B.C.D}

Example

Configuring FTP connection to 192.0.2.50:

Switch:1> enable
Switch:1# virtual-service figw console
Connected to domain figw
Escape character is ^Y

  <cr>
FIGW> ftp 192.0.2.50

Variable Definitions

The following table defines the variable for ftp command.

Variable Value
{A.B.C.D} Specifies the IP Address to establish the FTP connection with.
9037588-00 Rev AA