Clearing NEAP session

Use this procedure to clear the NEAP session that is learnt on the switch.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Clear the NEAP session:

clear eapol non-eap [<0x00:0x00:0x00:0x00:0x00:0x00>] [{slot/port[/sub-port][-slot/port[/sub-port]][,...]} <0x00:0x00:0x00:0x00:0x00:0x00>]

Switch:1> enable
Switch:1# configure terminal
Switch:1(config)# clear 1/16 00:1b:63:84:45:e6

The following table defines parameters for the clear eapol non-eap command.


Variable	Value
`{slot/port[/sub-port][-slot/port[/sub-port]][,...]}`	Specifies the port list on which the NEAP MAC is learnt.
`0x00:0x00:0x00:0x00:0x00:0x00`	Specifies the MAC-Address on the NEAP session.