Table View

The frame table can be customized to display the following information:


Column	Description
Time	Displays the time the frame was seen.
Source	Lists the device where the frame originated.
Destination	Lists the device where the frame was sent.
BSSID	Displays the Basic Service Set Identifier.
Transmitter	Lists the device that transmitted the frame.
Receiver	Lists the device that actually received the frame.
Address 1	Lists the first address in the frame.
Address 2	Lists the second address in the frame.
Address 3	Lists the third address in the frame.
Address 4	Lists the fourth address in the frame.
Observed Channel	Lists the WLAN channel that the device is operating on.
Channel Extension	Lists the WLAN channel extension that the device is operating on.
Rate	Displays the data rate (in Mbps) being used by the device that sent the packet.
Signal (dBm)	Lists the device's signal strength connectivity on the WLAN.
Size	Displays the size of the frame.
802.11 Type	Displays the 802.11 protocol type used in the frame.
Protocol	Displays the protocol type used in the frame.
Sensor	Displays the MAC address of the sensor that observed the device that sent the packet.

Column display and arrangement can be customized as follows:

Hide or unhide a category by right-clicking in the column heading area, and uncheck or checking the checkbox for a category (see below).
Rearrange columns by clicking on a column heading and dragging it to a new position.

When a frame is selected (highlighted), the frame data is shown in the hex values and decodes areas.

The decodes area shows the 802.11 interpretation of the frame data in a tree structure. The hex values area and decodes area are linked so that selections in one area will follow the selections in the other.