Actions

You may specify one or more actions to run when certain conditions are met as defined by the filter(s). Valid actions are:

• Classify Devices - Classifies devices using the filter(s) to determine which devices are to be classified.
• Clear active alarm for active devices - Clears any active alarm if the conditions defined in the filter(s) are met.
• Set Client Type - Sets the Client Type for Wireless Clients as defined in the filter(s).
• ACL - Enables the Access Control List on switches that meet the conditions defined in the filter(s).
• Port Suppression - Suppresses communication between unauthorized devices and switches on your network as defined in the filter(s).
• Termination - Terminates devices that meet the conditions defined in the filter(s).
• AP Test - Runs an AP Test using the specified profile if the conditions defined in the filter(s) are met.
• Frame Capture - Monitors and analyzes real-time data traffic flow from devices in your wireless LAN and saves the data in a file if the conditions defined in the filter(s) are met.
• Vulnerability Assessment - Runs an vulnerability assessment using the specified profile if the conditions defined in the filter(s) are met.
• Delete Device - Deletes any device from your system that meets the criteria defined in the filter(s).

When an action is selected, an Edit button is displayed. Click the Edit button to configure the action. Configuration will be different for each type of action. For example, selecting Classify Devices as your action displays the following dialog window.

Classify Devices allows you to classify devices as: Sanction (Inherit Profiles), Unsanctioned, Neighboring, or Sanction (Assign Profiles). Click the Save and Close button to save the configuration and exit the dialog window.

The following screen shot shows an example of a fully defined filter and action.

You can remove an action by clicking the x next to the action.

Click the Save and Close button to save the rule set and exit the window.