SNMP Trap Configuration

You can enable SNMP Trap reception by following these steps:

  1. Type snmpt at the command prompt. A SNMP status message is displayed to alert you that SNMP trap reception is enabled or disabled.
  2. At the prompt, type e to enable SNMP trap reception.
  3. Type q to return to the Config menu. You are prompted to save your changes.
  4. Type yes and press [Enter] to save your change (or no to disregard your change). Status messages for SNMP are displayed indicating if the status is OK or not.
  5. Press [Enter] to display the Config menu.

    The SNMP daemons are stopped and then restarted. The Config menu is displayed.

9037079-00