APs - Properties

You can view the properties of an AP by clicking the drop-down menu button

and clicking Properties.

The following information is displayed:


Field	Description
Name	The name of the AP.
Description	A description of the AP.
Last Audit	The date and time of the last audit.
Host Address	IP address of the AP.
Flagged	Flag an AP that you want to bring attention to.
In compliance / Not in compliance	Status of the last compliance audit. Click the Managed Configuration button to display the configuration. Click the Generated Configuration button to display a generated configuration for a device. The generated configuration is the same configuration sent to a relay server to configure a device. Click the Push Configuration button to push the existing configuration out to the .
Observed Data	Data that AirDefense Services Platform observed about the . You can filter the observed data by entering significant text in the Search field.

The scope of the AP is shown under the Scope tab. The Autoplace button can be used to place the AP in a network folder using Auto-Placement rules.

Alarms related to the AP are shown in the Alarms tab. The Actions button can be used to perform one of the listed functions on a selected (highlighted) alarm.

You can view and/or override the AP configuration by selecting:

CLI Configuration
Channel Settings
Device Access
Radio Settings
RF-Domain
Relay Server
Communication Settings Profile
WLAN Profiles
WLAN Profiles—Display valid licenses for APs.

These configuration settings (or profiles) are all located in the Configuration Tab.

If you make changes, click Save to save them.

Click the Delete Device button to remove a device from your network.

Click the Close buttonX to close the Properties overlay.