Network filters are provided to filter the displayed network
information. They are displayed on the left side of the Network tab.
The different filters are:
Grouping - you can view
devices by grouping them using similar criteria.
Network Scope - you can view
devices according to where they are in the network tree.
First/Last Seen Filter -
filters devices according to when they where first seen and/or last seen on your
network.
Flag - you can optionally view
all flagged devices.
Alarm Severity - you can view
devices by alarm criticality.
Alarm Type - filters devices
by alarm type.
Device - filters devices by
model, manufacturer, and/or capabilities.
Compliance - displays devices
according to state of compliance with network policies.
Status - displays devices
according to their uptime/offline status.
Signal Strength - filters
devices within a specific signal strength range.
Security-Sensed Filter -
displays devices using a combination of the sensed method of authentication and/or
the sensed method of encryption.
Security-Polled Filter -
devices using a combination of the polled method of authentication and/or the polled
method of encryption.
The filters are initially set to display the maximum amount of
devices. You can adjust any filter or combination of filters to fine tune the display of
devices. This allows you to display only the devices that you want to view.
The indicator on the right of each filter turns green when you change a filter from its original state. Click the
green indicator to return a filter to its default state.
when you change a filter from its original state. Click the
green indicator to return a filter to its default state.