ADSP uses a centralized Polling feature to manage configuration audits, status polling and data collections from one location.
You have an option to enable polling for supported devices. When enabled, WMS automatically polls for device network status at an interval defined by a user supplied frequency value (default frequency is 1 hour).
You may configure polling at the appliance network level all the way down to the floor network level, but you should always configure polling at the appliance level. Any network level below the appliance level will inherit the configuration. If you need to have a different configuration below the appliance level, use the Override settings option.
Note
The Override settings option is available when you select (highlight) a network level below the appliance level. Use the Expand
button to
reveal the other levels.Select the Enable automatic status polling checkbox to enable polling for supported devices. When enabled, WMS automatically polls for device network status at an interval defined by the supplied Frequency value.
Each device model has an associated data collection profile which identifies the list of attributes collected periodically from the device. Select the Enable automatic data collection checkbox to collect these SNMP attributes at a Frequency defined by you. You can also select the Automatically correct configuration compliance violations checkbox to enable ADSP to correct configuration compliance violations by uploading the last approved configuration to the target device.
The following features can be enabled by selecting the appropriate checkbox:
If you have a Central Management license and there are multiple appliances in your system, after configuring polling, you can copy the configuration to all appliances in the system.
Click the Apply button to save your changes. Click the Reset button to discard your changes.