Displays the MPLS (Multiprotocol Label Switching) contents of the IP routing table.
| lsp_name | Specifies an LSP name. |
| vlan_name | Specifies a VLAN (Virtual LAN) name. |
| permanent | Specifies permanent routing. |
| ip_address | Specifies an IP address. |
| netmask | Specifies a subnet mask. |
| unicast | Displays unicast routes. |
| vrname | Specifies a VR or VRF. |
N/A.
A c flag in the Flags column indicates a compressed route resulting from enabling compression using the enable iproute compression command. The total number of compressed routes is also shown.
All routes that are provided to the FIB display the f flag.
If you do not specify a VR or VRF, the command applies to the current VR context.
The following example example displays detailed information about all IP routing:
Switch.3 # show iproute mpls
This command was first available in ExtremeXOS 12.2.2.
This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X590, X620, X690, X870 series switches.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB