This command displays tech-support configuration and report status.
| hostname | Specifies the host name of the collector. |
| ip_address | Specifies the IPv4 address of the collector. |
NA.
This commands displays tech-support configuration and report status, such as last report stats, when the next cyclic report is sent if report frequency daily is configured, and when the next one time report is sent if one time report is scheduled with run tech-support in hours command. If you do not specify a hostname or IP address, this command displays configuration and report status for all existing collectors; otherwise it displays configuration and report status for the specified collector.
The following is an example of the show output:
Print
this page
Email this topic
Feedback
View PDF
Download EPUB
Tech Support Collector: Enabled
Report Collector: 10.5.2.107
TCP Port: 9998
Virtual Router: VR-Mgmt
Source IP Addr: 10.66.24.234
SSL: Off
Report Mode: Automatic
Report Data Set: Summary
Report Frequency: Error-detected AND Daily at 0:00
Last Report: Successful
Sent On: Thu Feb 21 05:06:32 2013
From: 10.66.24.234:3546
To: 10.5.2.107:9998
SSL: Off
Error: None
Next Cyclic Report: Scheduled on Fri Feb 22 00:00:00 2013
Next One Time Report: Not Scheduled
Report Collector: 10.5.2.108
TCP Port: 800
Virtual Router: VR-Mgmt
Source IP Addr: 10.66.24.234
SSL: On
Report Mode: Automatic
Report Data Set: Detail
Report Frequency: Bootup AND Daily at 0:00
Last Report: Failed
Sent On: Thu Feb 21 05:06:32 2013
From: 10.66.24.234:3598
To: 10.5.2.107:800
SSL: On
Error: Socket time out
Next Cyclic Report: Scheduled on Fri Feb 22 00:00:00 2013
Next One Time Report: Not Scheduled
This command was first available in ExtremeXOS 15.4.
This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X590, X620, X690, X870 series switches.