This command is used to refresh a specific network zone, or all the network zones.
| network-zone | Specifies the logical group of remote devices. |
| zone_name | Specifies the network_zone name. |
| all | Refresh all the network-zones. |
N/A.
Use this command to refresh a specific network zone, or all the network zones.
When you issue the command to refresh a network-zone, or all network-zones, it can take a long time to clear the CLI because each individual policy must be converted before it is refreshed. The command succeeds, or fails, only after it receives a response for all policy refresh results from the hardware.
If the refresh fails for a specific zone, the following error message will be printed on the console.
Switch # refresh access-list network-zone zone1 ERROR: Refresh failed for network-zone "zone1".
The following example refreshes all policies in “zone1”:
refresh access-list network-zone zone1
This command was first available in ExtremeXOS 15.2.
This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X590, X620, X690, X870 series switches.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB