Enables port up/down trap reception for specified ports.
|
port_list |
Specifies one or more ports or slots and ports. |
|
all |
Specifies all ports on the switch. |
Enabled.
Use this command to begin receiving SNMP (Simple Network Management Protocol) trap messages when a port transitions between being up and down.
The following command enables ports 3, 5, and 12 through 15 on a stand-alone switch to receive SNMP trap messages when the port goes up/down:
enable snmp traps port-up-down ports 3,5,12-15
This command was first available in ExtremeXOS 10.6.
This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X590, X620, X690, X870 series switches.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB