configure network-clock ptp boundary add unicast-slave

configure network-clock ptp boundary add unicast-slave ipv4_address {vlan} vlan_name

Description

Add an entry to the unicast slave table for a PTP clock instance. This command is available only for boundary clocks.

boundary	Boundary clock instance.
unicast-slave	IP addresses that are potential slaves to the local clock.
ipv4_address	IPv4 address.
vlan	VLAN (Virtual LAN).
vlan_name	Name of the specific VLAN to add for the PTP clock instance.

The default configuration of clock port is slave mode.

Use this command to add an entry to the unicast slave table for a PTP clock instance.

The following command adds a static unicast slave entry to the PTP clock port lpbk-slave in the boundary clock:

configure network-clock ptp boundary add unicast-slave 192.168.15.20 vlan lpbk-slave

This command was first available in ExtremeXOS 15.1.

This command is available on Summit X770, X670-G2, and X460-G2 series switches.

Note

PTP commands can be used only with the Network Timing feature pack.

Published July 2019prev | next