configure access-list width

configure access-list width [double | single] [slot slotNo | all]

Description

Configures the TCAM width of a switch.

double	Specifies a double wide ACL (Access Control List) TCAM. Provides double wide ACL key with additional qualifiers.
single	Specifies a single wide ACL TCAM.
slotNo	Specifies the slot to configure.
all	Specifies all slots.

Single.

Note

This command is not applicable to the ExtremeSwitching X870 series switches. Key width is applied automatically on X870 switches.

Use this feature to configure the width of the ACL TCAM key of a slot or switch to be either double wide or single wide.

The switch must be rebooted for the configuration change to take effect.

If you attempt to configure a double wide mode on a slot or switch that does not support it, an error message is displayed.

To display the configured mode, use the show access-list width command.

The following command configures slot 1 to use double wide mode:

configure access-list width double slot 1

This command was first available in ExtremeXOS 12.5.

Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620.

Published July 2019prev | next