Configures the autopolarity detection feature on the specified Ethernet ports.
|
port_list |
Specifies one or more ports on the switch. |
|
off |
Disables the autopolarity detection feature on the specified ports. |
|
on |
Enables the autopolarity detection feature on the specified ports. |
Enabled.
This feature applies to only the 10/100/1000 BASE-T ports on the switch and copper medium on Summit combination ports.
When autopolarity is disabled on one or more Ethernet ports, you can verify that status by using the following command:
show ports information detail
The following command disables the autopolarity detection feature on ports 5 to 7 on a Summit series switch:
configure ports 5-7 auto-polarity off
This command was first available in ExtremeXOS 11.2.
This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X590, X620, X690, X870 series switches.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB