configure ports protocol filter

configure ports [port_list | all] protocol filter [none | filter_name]

Description

Configures protocol filtering on a port.

port_list	Specifies the port list separated by a comma ( , ) or dash ( - ).
all	Specifies all ports.
protocol filter	Specifies the protocol filter.
none	Specifies to not perform protocol filtering on specified ports.
filter_name	Specifies the protocol filter name.

Disabled.

Use this command to configure protocol filtering on a port.

The following example unbinds the L2PT profile from peer 1.1.1.1 of VPLS cust2:

configure l2vpn vpls cust2 peer 1.1.1.1 l2pt profile none

The following example enables filtering of protocols in my_list on port 1:

configure ports 1 protocol filter "my_list"

The following example disables protocol filtering on port 7:

configure ports 7 protocol filter none

This command was first available in ExtremeXOS 15.5.

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X590, X620, X690, X870 series switches.

Published July 2019prev | next