Displays general loading sharing information.
| port | View load sharing information for a specific port. |
| port_number | View load sharing information for a specific port. |
| detail | Show details for the specified ports in the load sharing group. |
N/A.
The following example shows load sharing information for the switch:
Print
this page
Email this topic
Feedback
View PDF
Download EPUBLoad Sharing Monitor
Config Current Agg Min Ld Share Ld Share Agg Link Link Up
Master Master Control Active Algorithm Flags Group Mbr State Transitions
================================================================================
1:47 1:47 LACP 1 L2 A 1:47 Y A 1
L2 1:48 Y A 1
120:50 120:50 LACP 1 custom A 120:50 Y A 1
custom 120:52 Y A 1
122:50 LACP 1 custom Ad 122:49 - A 2
custom 122:50 - A 2
================================================================================
Link State: A-Active, D-Disabled, R-Ready, NP-Port not present, L-Loopback
Minimum Active: (<) Group is down. # active links less than configured minimum
Load Sharing Algorithm: (L2) Layer 2 address based, (L3) Layer 3 address based
(L3_L4) Layer 3 address and Layer 4 port based
(custom) User-selected address-based configuration
Custom Algorithm Configuration: ipv4 L3-and-L4, xor
Custom Hash Seed: Switch MAC address (0x969D5262)
Flags:
A - All: Distribute to all members,
d – Dynamically created shared port,
L - Local Slot: Distribute to members local to ingress slot,
P - Port Lists: Distribute to per-slot configurable subset of members,
R - Resilient Hashing enabled.
Number of load sharing trunks: 3
This command was first available in ExtremeXOS 11.0.
Extended Edge Switching ring topology changes added in ExtremeXOS 22.7.
This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X590, X620, X690, X870 series switches.