configure stpd trap topology-change

configure stpd stpd_name trap topology-change {edge-ports}[on | off]

Description

Enables and disables the topology change trap for all ports or edge ports only.

stpd_name	Specifies an STPD (Spanning Tree Domain) name on the switch.
edge-ports	Specifies that topology change traps will be sent only for edge ports.
on	Enables the topology change trap.
off	Disables the topology change trap.

By default, the topology change trap is disabled (off) for all ports.

You cannot enable the topology change trap for edge ports if you have disabled the topology change trap for all ports.

The following example disables the topology change trap for edge ports only in the STP (Spanning Tree Protocol) domain r1.

configure stpd r1 trap topology-change edge-ports off

This command was first available in ExtremeXOS 15.7.1.

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X590, X620, X690, X870 series switches.

Published July 2019prev | next