Configures the switching mode as either cut-through or store-and-forward.
| cut-through | Specifies that a packet can begin being transmitted prior to its being received in full. |
| store-and-forward | Specifies that a packet is transmitted only after the entire packet has been received and stored in the packet memory. |
Store-and-forward.
Use this command to configure the switch to begin transmitting a packet before its entire contents have been received. This reduces the forwarding latency of the switch.
Cut-through mode cannot be achieved for packet sizes that are less than or equal to 384 bytes. On the Summit X770 and X670-G2, cut-through can be achieved for all packet sizes.
To display the switch mode settings, use the show forwarding configuration command.
This command was first available in ExtremeXOS 12.3.
Cut-through forwarding mode is supported only on the 40G ports of the Summit X770, ExtremeSwitching X670-G2, X870, and X690 series switches; and 100G ports on ExtremeSwitching X870 series switches.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB