Partitions 100G and 40G ports into multiple partition speeds.
|
port_list |
Specifies one or more ports. |
|
all |
Specifies all ports. |
| 1x100G |
Specifies partitioning a 100G port into a single 100G port (applies only to switches with 100G port(s)). |
| 1x40G |
Specifies partitioning a 40G port into a single 40G port (applies only to switches with 40G port(s)). |
| 2x50G |
Specifies partitioning a 100G port into a two 50G port (applies only to switches with 100G port(s)). |
|
4x10G |
Specifies partitioning a 40G port into a four 10G port (applies only to switches with 40G port(s)). |
|
4x25G |
Specifies partitioning a 100G port into a four 25G port (applies only to switches with 100G port(s)). |
For 40G ports the default partition is 1x40G.
For 100G ports the default partition is 1x100G.
Use this command to partition 100G and 40G ports into multiple partition speeds.
The following example partitions port 6:1 into 4 10G ports:
configure ports 6:1 partition 4x10G Warning: Configuration will be lost on ports 6:1 No configuration changes should be made on these ports until after the next reboot. This command will only take effect after save configuration and either reboot switch or disable and enable slots 6. Are you sure you want to continue? (y/N)
This command was available in ExtremeXOS 12.6.
This command was expanded to include partitioning 100G ports in ExtremeXOS 22.2
QSFP28 and QSFP+ Port Partitioning
| Switch Model | Port Bandwidth | Each Physical Port Can Operate as.... |
|---|---|---|
| X670-G2-48x-4q QSFP+ |
40 Gb | One 40 Gb port or Four 10 Gb ports |
| X770 (all models) QSFP+ |
40 Gb | One 40 Gb port or Four 10 Gb ports |
| X590 (all models) QSFP28 and QSFP+ |
100 Gb | One 100 Gb port or Two 50 Gb ports or Four 25 Gb ports |
| 40 Gb | One 40 Gb port or Four 10 Gb ports |
|
| X690 (all models) QSFP28 and QSFP+ |
100 Gb | One 100 Gb port or Two 50 Gb ports or Four 25 Gb ports |
| 40 Gb | One 40 Gb port or Four 10 Gb ports |
|
| X870 (all models) QSFP28 and QSFP+ |
100 Gb | One 100 Gb port or Two 50 Gb ports or Four 25 Gb ports Note: On
X870-96x-8c series switches, an optional Switch Port Speed
License is required to increase the data rate to 100 Gb on
physical ports 1 through 24. No license is required for 100 Gb
capability on physical ports 25 through 32.
|
| 40 Gb | One 40 Gb port or Four 10 Gb ports |
Print
this page
Email this topic
Feedback
View PDF
Download EPUB