Configure System Parameters
About this task
Configure individual system-level switch parameters to configure global options for the switch.
Procedure
Example
Switch:1> enable
Switch:1# configure terminal
Configure the system, or root level, prompt name for the switch:
Switch:1(config)# sys name Floor3Lab2
Variable Definitions
The following table defines parameters for the sys command.
|
Variable |
Value |
|---|---|
|
clipId-topology-ip
Note:
Exception: Only supported on VSP 8600 Series |
Configures the topology ip from the available CLIP. WORD<1-256>specifies the Circuitless IP interface id. |
|
control tcp-timestamp |
Enables or disables TCP Timestamp. |
|
force-msg |
Adds forced message control pattern. WORD<4–4> Enter force message pattern. |
|
force-topology-ip-flag
Note:
Exception: Only supported on VSP 8600 Series |
Flags set to force choice of topology flag. enable |
|
msg-control |
Configures system message control feature. |
|
mtu <1522-9600> |
Configures Jumbo frame support for the data path. The value can be either 1522, 1950 (default), or 9600 bytes. |
|
name WORD<0–255> |
Configures the system, or root level, prompt name for the switch. WORD<0–255> is an ASCII string from 0–255 characters (for example, LabSC7 or Closet4). |
|
power |
Enables power to specified slot(s). |
|
security-console |
Enables the security console. |
|
software |
Configures software configuration. |
|
priv-exec-password |
Enables authentication for the Privileged EXEC CLI command mode. |