Configures the TCAM width of a module or switch.
| double | Specifies a double wide ACL TCAM. Provides double wide ACL key with additional qualifiers. |
| single | Specifies a single wide ACL TCAM. |
| slotNo | Specifies the slot to configure. |
| all | Specifies all slots. |
Single.
Use this feature to configure the width of the ACL TCAM key of a slot or switch to be either double wide or single wide.
The switch must be rebooted for the configuration change to take effect.
If you attempt to configure a double wide mode on a slot or switch that does not support it, an error message is displayed.
To display the configured mode, use the show access-list width command.
The following command configures slot 1 to use double wide mode:
configure access-list width double slot 1
This command was first available in ExtremeXOS 12.5.
This command is available only on BlackDiamond X8 series switches, BlackDiamond 8000 c-, xl-, and xm-series modulesE4G-200 and E4G-400 switches, and Summit X440, X450-G2, X460, X460-G2, X480, X670, X670-G2, and X770 series switches whether or not included in a SummitStack.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB