Enables/disables an IPv4 peer (far-end) for the specified CES pseudowire. This command only supports to MPLS PSN transport CES pseudowires.
This command enables or disables a specific PW configured for the specified ces_name. By default, the PW is enabled when it is configured. When a PW is disabled, the switch signals preferred forwarding status of Standby to the PW peer and the switch ceases transmitting or receiving data packets over the PW. The PW label is not withdrawn. Packets may still be sent and received over the PW's G-ACh. When the PW is re-enabled, the switch signals preferred forwarding status Active to the PW peer.
|
ces |
Circuit Emulation Service. |
|
ces_name |
Alphanumeric string identifying the CES pseudowire. |
|
peer |
Enable/disable the peer of the CES pseudowire. |
|
ipaddress |
IPv4 Address; type=ipv4_t. |
The default administrative state is enable.
Use this command to enable/disable an IPv4 peer (far-end) for the specified CES pseudowire. This command only supports to MPLS PSN transport CES pseudo-wires.
This command was first available in ExtremeXOS 15.1.
This command is available on the cell site routers (E4G-200 and E4G-400).
Print
this page
Email this topic
Feedback
View PDF
Download EPUB