enable ip-security anomaly-protection tcp flags

enable ip-security anomaly-protection tcp flags {slot [ slot | all ]}

Description

Enables TCP flag checking.

Syntax Description

`slot`	Specifies the slot to be used.
all	Specifies all IP addresses, or all IP addresses in a particular state.

Default

The default is disabled.

Usage Guidelines

This command Enables TCP flag checking. This checking takes effect for both IPv4 and IPv6 TCP packets. When enabled, the switch drops TCP packets if one of following condition is true:

TCP SYN flag==1 and the source port<1024
TCP control flag==0 and the sequence number==0
TCP FIN, URG, and PSH bits are set, and the sequence number==0
TCP SYN and FIN both are set.

History

This command was first available in ExtremeXOS 12.0.

Platform Availability

This command is only available on the Summit X440, X460, X460-G2, X480, and X670, X670-G2 platforms, whether or not included in a SummitStack, and the BlackDiamond X8 series switches, BlackDiamond 8000 c-, e-, xl-, and xm-series modules.

Published August 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback