Allows you to Telnet from any source node to any other target node when both nodes are in the same active topology.
| slot-number | Specifies the number of a slot that is currently occupied by the intended target node. |
N/A.
When the target node accepts the related TCP connection, it prompts the user for a user ID and password. If the failsafe account is used, user ID and password authentication takes place on the specified node. Otherwise, authentication takes place on the master node, regardless of the source and target nodes used.
Telnet must be enabled on the SummitStack for this command to function.
The following command accesses the node in slot 2:
Slot-1 Stack.6 # telnet slot 2 Entering character mode Escape character is '^]'. telnet session telnet0 on /dev/ptyb0 login: admin password: ExtremeXOS Copyright (C) 2000-2007 Extreme Networks. All rights reserved. Protected by US Patent Nos: 6,678,248; 6,104,700; 6,766,482; 6,618,388; 6,034,957; 6,859,438; 6,912,592; 6,954,436; 6,977,891; 6,980,550; 6,981,174; 7,003,705; 7,012,082; 7,046,665; 7,126,923; 7,142,509; 7,149,217; 7,152,124; 7,154,861. ============================================================================== You are connected to a Backup node. Only a limited command set is supported. You may use "telnet slot <slot_number>" to connect to the Master node to access the full set of commands. Press the <tab> or '?' key at any time for completions. Remember to save your configuration changes. Slot-2 Stack.1 >
This command was first available in ExtremeXOS 12.0.
This command is available only on SummitStack.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB