Configures the stacking port protocol.
| standard |
Specifies the standard protocol, which is supported on all SummitStack capable switches. |
| enhanced |
Specifies the enhanced protocol, which is supported only on Summit X440, X460, X480, and X670 switches. The enhanced protocol is required to support MPLS. |
Standard.
Use this command to change the configured stacking protocol on a stack made up of Summit X440, X460, X480, or X670 switches.
Note
You must reboot the switch to activate the protocol change.
If MPLS is enabled on the switch, you must disable MPLS before you can change the stacking protocol to standard.
To display the stacking protocol configuration, enter the show stacking configuration command.
To configure a switch to use the enhanced protocol, enter the following command:
configure stacking protocol enhanced
This command was first available in ExtremeXOS 12.5.
This command is available only on Summit X440, X460, X480, and X670 switches.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB