Enables IP forwarding over MPLS LSPs for the default VR.
This command has no arguments or variables.
Disabled.
This command enables IP forwarding over MPLS LSPs for the default VR. When enabled, LSP next hops can be used to tunnel IP traffic across the MPLS network. By default, IP forwarding over MPLS LSPs is disabled.
Note
You can enable the use of LSP next hops, or you can enable DHCP/BOOTP relay. The software does not support both features at the same time.The following command enables IP forwarding over MPLS LSPs:
enable iproute mpls-next-hop
This command was first available in ExtremeXOS 11.6.
This command is available only on the platforms that support MPLS as described in the Feature License Requirements document.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB