unconfigure log target format

unconfigure log target [console | memory-buffer | nvram | session | syslog [all | ipaddress | ipPort {vr vr_name} [local0...local7]]] format

Description

Resets the log target format to its default values.

console	Specifies the console display format.
memory-buffer	Specifies the switch memory buffer format.
nvram	Specifies the switch NVRAM format.
session	Specifies the current session (including console display) format.
syslog	Specifies a syslog target format.
all	Specifies all remote syslog servers.
`ipaddress`	Specifies the syslog IP address.
`ipPort`	Specifies the UDP port number for the syslog target.
`vr_name`	Specifies the virtual router that can reach the server IP address. Note: User-created VRs are supported only on the platforms listed for this feature in the Feature License Requirements document.
local0 ... local7	Specifies the local syslog facility.
format	Specifies that the format for the target will be reset to the default value.

When a target format is unconfigured, it is reset to the default values.

The following defaults apply to console display, memory buffer, NVRAM, and session targets:

The following defaults apply to syslog targets (per RFC 3164):

Use this command to reset the target format to the default format.

The following command sets the log format for the target session (the current session) to the default:

unconfigure log target session format

This command was first available in ExtremeXOS 10.1.

The UDP-port parameter was added in ExtremeXOS 16.2.

This command is available on all platforms.

Published August 2016prev | next