Displays connectivity and configuration information for neighboring Extreme Networks switches.
|
all |
Specifies all ports. |
|
ports |
Specifies one or more ports or slots and ports. |
|
detail |
Show detailed information. |
N/A.
On a modular switch, ports can be a list of slots and ports. On a stand-alone switch, port_list can be one or more port numbers. For a detailed explanation of port specification, see Port Numbering. To clear the counters, use the clear lacp counters command.
The neighbor-ID value is eight bytes. The first two bytes are always set to 00:00; the last six bytes are set to the neighbor‘s system MAC address.
Use this command to display neighboring switches and configurations. This is most effective with Extreme Networks switches.
The following command displays the configuration of the switch:
show edp
Following is sample output from this command:
EDP advert-interval :60 seconds EDP holddown-interval :180 seconds EDP enabled on ports :1:1 1:2 1:3 1:4 1:5 1:6 3:1 3:2 3:3 3:4
Following is sample output from the show edp ports 1:1 command:
Port Neighbor Neighbor-ID Remote Age Num Port Vlans ============================================================================= 1:1 Oban 00:00:00:30:48:41:ed:97 1:1 54 1 =============================================================================
The following command displays the connectivity and configuration of neighboring Extreme Networks switches:
show edp ports 1:1 detail
Following is sample output from this command:
============================================================================= Port 1:1: EDP is Enabled Tx stats: sw-pdu-tx=2555 vlan-pdu-tx=1465 pdu-tx-err=0 Rx stats: sw-pdu-rx=2511 vlan-pdu-rx=2511 pdu-rx-err=0 Time of last transmit error: None Time of last receive error: None Remote-System: Oban Age = 41 Remote-ID: 00:00:00:30:48:41:ed:97 Software version: 11.1.0.19 Remote-Port: 1:1 Port Type: Ethernet Auto Negotiation: OFF Flow Control: SYMMETRIC/ASYMMETRIC Duplex Speed: Configured = HALF Actual = HALF Port Speed (MB): Configured = ERROR Actual = 100 Mbps Remote-Vlans: test (4094) Age = 41 =============================================================================
Note
The output differs if the port is connected to a port running ExtremeWare® software; the output shown above is displayed when both connected ports are running ExtremeXOS software.
This command was first available in ExtremeXOS 10.1.
This command is available on all platforms.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB