Use this command to configure a route-distinguisher (RD) for a VPN VRF.
| vrf_name | Specifies the name of a VPN VRF. |
| rd | Specifies a Route Distinguisher for a VRF. It can be either ASN-related, where it is represented as 2-byte AS number:4-byte num. It can be IP-address based where it is represented as 4-byte IP address:2-byte number. |
| 2_byte_as_num | Specifies a 2-byte Autonomous System (AS) number. |
| 4_byte_number | Specifies a 4-byte number to further identify the RD. This number can be chosen by organization that configures the RD, and this number does not need to match any other network configuration parameters. |
| ip_address | Specifies an IP address to include as part of the RD. |
| 4_byte_as_num | Specifies a 4-byte AS number. |
| 2_byte_number | Specifies a 2-byte number to further identify the RD. This number can be chosen by the organization that configures the RD, and this number does not need to match any other network configuration parameters. |
N/A.
Here is an example: 9643:7000
Here is an example: 10.203.134.5:324
Note
Although Route Distinguisher is eight-bytes wide, this CLI accepts only six bytes value. The first two bytes ("type" field) is deduced from the values entered on the CLI, so it is redundant to set the type field on the CLI too. If 2-byte as-num:4-byte num is entered on the CLI, the type field is automatically set to 0. If ip_address:2_byte_number is entered on the CLI, the type field is automatically set to 1. Type 2 (4-bytes AS number) Route Distinguisher is not supported.
Route Distinguisher is a mandatory parameter for a VRF. Without this parameter, a VRF cannot be active and local VPN routes cannot be advertised across the SP‘s backbone to the remote VPN sites.
Use this command to configure or change the RD for a VPN VRF. If you use this command to change the RD, the Layer 3 VPN associated with that VPN VRF is reset by automatically disabling and re-enabling the VRF.
RD is added to the beginning of the VPN customer‘s IPv4 prefix to make globally unique VPNv4 prefixes. You must configure RD for a VRF to be functional. This command is not applicable for a heavy-weight traditional VR.
The following examples configure RDs using the two of the supported formats:
configure vr corporate-extreme rd 10.203.134.5:324
configure vr corporate-guest rd 9643:7000
This command was first available in ExtremeXOS 15.3.
This command is available on BlackDiamond8900 xl- and xm-series modules and Summit X460, X480, X670, and X770 switches.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB