Allows you to choose the destination MAC type for sending CFM PDUs for an MA.
domain_name |
Enter the domain associated with the MA you are configuring. |
association_name |
IEEE 802.1ag or ITU-T Y.1731 association name. |
unicast |
CFM PDUs are sent to the unicast MAC address configured in static remote MEP creation. |
multicast |
CFM PDUs are sent to the standard multicast destination address. |
Multicast.
Use this command to change the MAC type on a previously configured MA. If multicast is selected, CFM PDUs are sent to the standard multicast destination. If unicast is selected, CFM PDUs are sent to the unicast MAC address configured in static remote MEP creation.
Use the show cfm command to verify your configuration.
E4G400, E4G200, and Summit X460 do not support unicast CCM (Continuity Check Message) generation. When the user configures the destination MAC type as unicast, the following message appears:
Error: IEEE 802.1ag PDUs can be sent only to standard multicast address on this platformThis command was first available in ExtremeXOS 12.1.
This command is available on all platforms.