Runs the Extreme Service Verification tool on the specified ports of the VLAN using the specified count and interval.
| vlan | Specifies the VLAN for the traffic test. |
| vlan_name | Specifies a VLAN name. |
| loopback-port | Specifies the loopback port for the traffic test. |
| loopback-port | Specifies the loopback-port. |
| peer-switch-ip | Specifies the peer switch for the traffic test. |
| ipaddress | Specifies the IP address of the peer switch. |
| packet-size | Specifies the size of packet to use for service verification. |
| packet_size | Specifies the size; the range is 64 - 9216. |
| rate | Specifies the maximum service utilization rate and rate value. |
| Kbps | Specifies K bits per second. |
| Mbps | Specifies M bits per second. |
| Gbps | Specifies G bits per second. |
| duration | Specifies the duration of time to run service verification. |
| time | Specifies the duration value; the range is 1-65534. |
| seconds | Specifies the time in seconds. |
| minutes | Specifies the time in minutes.. |
| hours | Specifies the time in hours. |
N/A.
Use this command to run the Extreme Service Verification tool on the specified ports of the VLAN using the specified count and interval.
The following example starts the Extreme Service Verification tool on vlan1, loopback port 2:
run esvt traffic-test v1 loopback-port 2 peer-switch-ip 2.2.2.2 packet-size 64 rate 200 Mbps duration 5 minutes
This command was first available in ExtremeXOS 15.3.
This command is available in X460, X460-G2, X480, E4G-200, E4G-400, X670, X670-G2, X770, Stacking, BDX8 and BD8800.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB