Stops sending log messages to the specified target.
In a stack, this command is applicable only to Master and Backup nodes and not applicable to the standby nodes.
| console | Specifies the console display. |
| memory-buffer | Specifies the switch memory buffer. |
| nvram | Specifies the switch NVRAM. |
| primary-msm | Specifies the primary
MSM. Note: This parameter is available only on modular
switches.
|
| primary-node | Specifies the primary node in a stack. |
| backup-msm | Specifies the backup
MSM. Note: This parameter is available only on modular
switches.
|
| backup-node | Specifies the backup node in a stack. |
| session | Specifies the current session (including console display). |
| syslog | Specifies a syslog target. |
| all | Specifies all of the remote syslog servers. |
| ipaddress | Specifies the syslog host name or IP address. |
| ipPort | Specifies the UDP port number for the syslog target. |
| vr_name | Specifies the virtual router
that can reach the server IP address. Note: User-created VRs are supported only on the platforms listed for
this feature in the Feature License Requirements document..
|
| local0 ... local7 | Specifies the local syslog facility. |
Enabled, for memory buffer, NVRAM, primary MSM, and backup MSM/MM; all other targets are disabled by default.
This command stops sending messages to the specified target. By default, the memory buffer, NVRAM, primary MSM/MM, and backup MSM/MM targets are enabled. Other targets must be enabled before messages are sent to those targets.
Configuration changes to the session target are in effect only for the duration of the console display or telnet session, and are not saved in FLASH. Changes to the other targets are saved to FLASH.
You can also use the following command to disable displaying the log on the console: disable log display
The disable log display command is equivalent to disable log target console-display command.
Note that the backup-msm target is only active on the primary MSM/MM, and the primary-msm target is only active on the backup MSM/MM.
The following example disables log messages to the current session:
disable log target session
This command was first available in ExtremeXOS 10.1.
The primary-msm and backup-msm options were first available in ExtremeXOS 11.0.
The ipPort parameter was first available in ExtremeXOS 11.0.
The UDP port parameter was added in ExtremeXOS 16.2.
This command is available on all platforms.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB