Selectively enables SNMPv3 default-group or default-user access on the switch.
| default-group | Specifies SNMPv3 default-group. |
| default-user | Specifies SNMPv3 default-user. |
Enabled.
This command is used to enable SNMPv3 default-group or default-user access.
Enabling SNMPv3 default-group access activates the access to an SNMPv3 default-group and the user- created SNMPv3-user part of default-group. Enabling the SNMPv3 default-user access allows an end user to access the MIBs using SNMPv3 default-user. This command throws an error if the SNMPv3 access is disabled on the switch.
The default groups are: admin, initial, v1v2c_ro, v1v2c_rw.
The default users are: admin, initial, initialmd5, initialsha, initialmd5Priv, initialshaPriv.
The following command enables the default users on the switch:
enable snmp default-user
This command was available in ExtremeXOS 12.2.
It was also included in ExtremeXOS 11.6.4 and ExtremeXOS 12.1.2.
This command is available on all platforms.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB