Selectively disables SNMP on the switch.
| snmp-v1v2c | Specifies SNMPv1/v2c access only. |
| snmpv3 | Specifies SNMPv3 access only. |
Enabled.
Disabling SNMP access does not affect the SNMP configuration (for example, community strings). However, if you disable SNMP access, you will be unable to access the switch using SNMP.
This command allows you to disable either all SNMP access, v1/v2c access only, or v3 access only.
To allow access, use the following command:
enable snmp access {snmp-v1v2c | snmpv3}The following command disables all SNMP access on the switch:
disable snmp access
This command was first available in ExtremeXOS 10.1.
SNMPv3 was added to ExtremeXOS 12.2. It was also included in ExtremeXOS 11.6.4 and 12.1.2.
This command is available on all platforms.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB