Displays the peer groups configured in the system.
| detail | Specifies to display the information in detailed format. |
| peer-group-name | Specifies a peer group. |
N/A.
If the detail keyword is specified then the parameters of the neighbors in the peer group, which are different from the ones that are configured in the peer group, are displayed.
If no peer group name is specified, all the peer group information is displayed.
This command applies to the current VR or VRF context.
The following command displays information for the outer peer group:
* (debug) Summit-PC.19 # show bgp peer-group "outer" Peer Group : outer Enabled : No AS : 65551 Router Enabled : Yes Weight : 1 ConnectRetry : 120 MinAsOrig : 15 HoldTimeCfg : 180 KeepaliveCfg : 60 Source Interface : Not configured RRClient : No Remove Private AS : No Router-Alert : Disabled Capabilities Config : ipv4-unicast ipv4-multicast route-refresh 4-Byte-AS Policy for NLRI Type ipv4-unicast In Policy : None Out Policy : None NextHopSelf : Disabled Send Communities : No Soft Input Recfg : Disabled Allow Looped AS-Path: No Policy for NLRI Type ipv4-multicast In Policy : None Out Policy : None NextHopSelf : Disabled Send Communities : No Soft Input Recfg : Disabled Allow Looped AS-Path: No Peers : 11.11.11.11 BGP Peer Group Statistics Total Peer Groups : 1 Enabled : 0 Disabled : 1
This command was first available in ExtremeXOS 10.1.
This command required a specific license in ExtremeXOS 11.1.
This command is available on platforms that support the appropriate license. For complete information about software licensing, including how to obtain and upgrade your license and which licenses support the BGP feature, see the Feature License Requirements document.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB