For Summit X480 series switches only:
configure ports port_list wan-phy loopback {off | internal | line}Configures the loopback options for the specified WAN PHY port.
|
port_list |
Specifies one or more ports or slots and ports. |
|
line |
Specifies the signal received from the optical media returns back to the transmitter. |
|
off |
Specifies no loopback. |
|
internal |
Specifies that the signal received from the system is sent
back to the system instead of the optical module.
Note: This
parameter is available only on Summit X480 series
switches.
|
Off.
Configuring loopback on a WAN PHY port is used for diagnostics and network troubleshooting.
XFP ports must be in WAN PHY mode. To configure the mode, use the configure ports port_list mode {lan | wan-phy} command.
The following command configures the loopback option on an WAN PHY capable port as off:
configure ports 1:3 wan-phy loopback off
This command was available in ExtremeXOS 11.6.
This command is available on 10G XFP ports only on Summit X480 series switches.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB