This command configures LSP flooding behavior for the specified interface.
|
vlan all |
Applies the configuration to all IS-IS VLANs. |
|
vlan_name |
Specifies a single VLAN to which the configuration applies. |
|
block-none |
Disables LSP blocking. |
|
block-all |
Blocks all LSPs. No LSPs are flooded out of the selected interface. |
|
block-group |
Blocks LSPs that contain the specified group ID. |
|
group_id |
Specifies a group ID number. The range is 1 to 4294967295. |
Block-none.
In a mesh environment, which is a set of fully interconnected point-to-point interfaces, LSP flooding can generate N2 PDUs because no router can tell which routers have and have not received the flooded LSP. By carefully selecting the links over which LSPs are flooded, traffic can be greatly reduced at the cost of some resiliency. Using mesh group IDs instead of a full block (the block-all option) allows a finer granularity of control.
The following command configures blocking on SJvlan for group 5:
configure isis SJvlan mesh block-group 5
This command was first available in ExtremeXOS 12.1.
This command is available on platforms with a Core license.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB