Displays the error information of the specified WAN PHY port.
|
port_list |
Specifies the port number. On a stand-alone switch, this value is just the port number, and on a modular switch, this value is the slot and port number. |
|
tag |
Specifies an 802.1Q or 802.1ad tag value. |
|
no-refresh |
Specifies a static snapshot of data. |
| refresh | Specifies a continous refresh of output. |
Real-time information.
Port number.
B1, B2, and B3.
Far end path block error count.
Far end line BIP error count.
If you do not specify a port number, range of ports, or tag value, the errors are displayed for all WAN PHY ports. The default display is a constantly refreshing real-time display. If you specify the no-refresh parameter, the system displays a snapshot of the data at the time you issue the command.
The tag value may be associated with either a VMAN or a VLAN.
The following command displays the errors for the LW XENPAK WAN PHY ports 1 to 4:
show ports 1-4 wan-phy errors
Following is sample output from this command:
WAN PHY Port Errors Port B1 B2 B3 FELBE FEPLE ========================================================================== 1 0123456789 0123456789 0123456789 0123456789 0123456789 2 0123456789 0123456789 0123456789 0123456789 0123456789 3 0123456789 0123456789 0123456789 0123456789 0123456789 4 0123456789 0123456789 0123456789 0123456789 0123456789 ================================================================================= 0->Clear Counters U->page up D->page down ESC->exit FELBE = Far End Path Block Error Count FEPBE = Far End Line BIP Error Count
This command was available in ExtremeXOS 11.6.
The tag value was added in ExtremeXOS 12.4.4.
The refresh keyword was added in ExtremeXOS 16.1.
This command is available on all 10G ports on 10G XFP ports only on the Summit X480 series switches only.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB