Disables the EAPS function for a named domain or for an entire switch.
| name | Specifies the name of an EAPS domain. |
Disabled for the entire switch.
Enter y to disable EAPS for a specific domain or the entire switch.
Enter n or press [Return] to cancel this action.
If you have considerable knowledge and experience with EAPS, you might find the EAPS loop protection warning messages unnecessary. For more information, see the configure eaps config-warnings off.
The following command disables the EAPS function for entire switch:
disable eaps
The switch displays the following warning message and prompts you to confirm this action:
WARNING: Disabling EAPS on the switch could cause a loop in the network! Are you sure you want to disable EAPS? (y/n) Enter y to disable EAPS on the switch. Enter n to cancel this action.The following command disables the EAPS function for the domain eaps-1:
disable eaps eaps-1
The switch displays the following warning message and prompts you to confirm this action:
WARNING: Disabling specific EAPS domain could cause a loop in the network!Are you sure you want to disable this specific EAPS domain? (y/n)Enter y to disable the EAPS function for the specified domain. Enter n to cancel this action.
This command was first available in ExtremeXOS 11.0.
The interactive messages were added in ExtremeXOS 11.4.
This command is available on all platforms.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB