Displays general information about a BFD session.
|
ipv4 |
Displays all IPv4 sessions. |
|
ipv6 |
Displays all IPv6 sessions. |
| ipaddress |
Displays session that has specified address as destination address. |
| vrname |
Displays sessions in specified VR. |
Displays all IPv4 sessions by default if ipv4 or ipv6 keyword is not specified.
Use this command to display general information about a BFD session.
The following command displays general information about the BFD session:
show bfd session vr all
Following is sample output from this command:
Neighbor Interface Clients Detection Status VR ============================================= 30.30.30.2 bfdVlan ----s 0 Down VR-Default ============================================= Clients Flag: m - MPLS, o - OSPF, s - Static NOTE: All timers in milliseconds.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB)
# show bfd session detail vr all
Neighbour : 10.10.10.1 Local : 10.10.10.2
Vr-Name : bfd_vr10 Interface : bfd_vlan10
Session Type : Single Hop State : Up
…
Up Count : 1
Last Valid Packet Rx : 00:51:49.300000
Last Packet Tx : 00:51:48.8200000
Hardware Assist : Yes
Neighbour : 10.10.11.1 Local : 10.10.11.2
Vr-Name : bfd_vr10 Interface : bfd_vlan11
Session Type : Single Hop State : Up
…
Up Count : 1
Last Valid Packet Rx : 00:51:49.300000
Last Packet Tx : 00:51:48.8200000
Hardware Assist : Yes
This command was first available in ExtremeXOS 12.4.
The hardware assist example output was added in ExtremeXOS 21.1.
This command is available on all platforms.