Enables or disables automatic recovery from parameter mismatch.
|
auto |
Allow automatic recovery from parameter mismatch. |
|
none |
Disable automatic recovery from parameter mismatch. |
The default is auto.
If interface parameters do not match during pseudowire signaling, the remote side may release our VC label which will prevent the pseudowire from coming up. If this is detected, the system will attempt automatic recovery to bring the pseudowire up if this configuration setting is auto. This automatic recovery can be disabled by setting the parameter mismatch recovery to none.
To disable automatic recovery:
config mpls ldp pseudo-wire parm-mismatch-recovery ces none
This command was first available in ExtremeXOS 15.1.
This command is available on the cell site routers (E4G-200 and E4G-400).
Print
this page
Email this topic
Feedback
View PDF
Download EPUB