configure network-clock clock-source output

configure network-clock clock-source output {bits-bnc-1 [1pps | 8KHz] bits-bnc-2 [E1 | T1 | 10MHz]}

Description

Configure the output network clock source as bits bnc 1 or 2.

The default output clock source for Bits Clock 1 BNC connector is 8 KHz, and the default for Bits Clock 2 BNC connector is E1 (2.048 MHz).

The E4G-200 and E4G-400 have clock sources beyond SyncE. The clock which drives all of the ports on a switch may be selected from:

SyncE (Synchronous Ethernet).
PTP – Precision Time Protocol, an optional 1588v2 module.
TDM – an optional module which has multiple T1/E1 interfaces for TDM/Ethernet interworking.
BITS – Building Integrated Timing Supply. A connector capable of receiving a timing signal provided by other building equipment.

The following command configures the region as T1:

configure network-clock clock-source input region t1

The following command configures the network-clock source as TDM:

configure network-clock clock-source input tdm

This command was first available in ExtremeXOS 15.1.

This command is available on X460-24x, X460-48x E4G-200 and E4G-400 switches. On X460 platforms only Sync-E option is available as clock-source.

Published August 2016prev | next