show network-clock ptp

show network-clock ptp

Description

Show the PTP clock recovery state information. The clock recovery using PTP event messages undergoes the following servo state changes:

  • Warmup - The local reference clock is in warmup state.

  • Fast Loop - The local reference clock is being corrected and the correction is converging.

  • Bridge - The local reference clock correction has been interrupted due to changes in the clocking information in the received PTP event messages or loss of PTP event messages.

  • Holdover - Prolonged loss of PTP event messages puts the local reference clock correction to holdover state.

  • Normal - The local reference clock correction has converged and the corrected clock is synchronous to the master clock information received in the PTP event messages.

Syntax Description

N/A.

Default

N/A.

Usage Guidelines

See Description.

Example

E4G-200.1 # show network-clock ptp
=====================================================================
Servo State Information
=====================================================================
Servo State             :  3 (Normal Loop)
Servo State Duration    :  10285 (sec)
=====================================================================

History

This command was first available in ExtremeXOS 15.1.

Platform Availability

This command is available on the cell site routers (E4G-200 and E4G-400).

Note

Note

PTP commands can be used only with the Network Timing feature pack.