unconfigure stacking-support

Description

This command resets the stacking parameters configured with commands that use the stacking-support keyword.

This command has no arguments or variables.

N/A.

Run this command from the local node on which you want to reset stacking-support parameters.

This command resets the stacking parameters configured with the following commands that use the stacking-support keyword:

To unconfigure the stacking-support parameters on the local node, use the following command:

unconfigure stacking-support
The stacking-support configuration has been reset.
The defaults will take effect at the next reboot of this switch.

This command was first available in ExtremeXOS 12.5.

This command is available on all platforms listed in Support for Alternate Stacking Ports in the ExtremeXOS 16.2 User Guide that support alternate stack port selection or permit disabling of the stacking-support option.

Published August 2016prev | next