Configures an anomaly rate-based notification feature.
| value | Specifies the number of events for the trigger. |
| slot | Specifies the slot to be used. |
| all | Specifies all IP addresses, or all IP addresses in a particular state. |
The default is 1.
This is a paired command with configure ip-security anomaly-protection notify trigger off that configures an anomaly rate-based notification feature. The anomaly notification is automatically triggered if the rate of anomaly events is greater than the configured ON value, and the notification is disabled if the rate falls below the value set in the configure ip-security anomaly-protection notify trigger off command.
The command takes effects after the anomaly notification is enabled.
Note
The value set in ON must be greater than or equal to the value set in OFF.
This command was first available in ExtremeXOS 12.0.
This command is only available on the Summit X440, X460, X460-G2, X480, X670, X670-G2, and X770 platforms, whether or not included in a SummitStack, and the BlackDiamond X8 series switches, BlackDiamond 8000 c-, e-, xl-, and xm-series modules.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB